Satmap active12 Guía de usuario descargar pdf (Pagina 46)

© Satmap Systems Ltd

© Satmap Systems Ltd 2014

46

6. MAIN MENU: Settings Menu (... cont)

6.14 Set Trip Data

(GPS MAP → MAIN MENU → Settings → Set

Trip Data)

This is where you can control how inactive

routes are displayed, as well as the deletion/

preservation of trail and trip log data when a

new route is activated.

Showing Inactive Routes

• Use the joystick, moving left/right to toggle

between;

Show Inactive Routes: Inactive routes are

shown on maps.

Hide Inactive Routes: Inactive routes are

hidden on maps.

Show Inactive Routes SP: The start point

(SP) of each inactive route is shown on the

maps. (A gray marker with a black triangle

appears at the start point).

• Press Done or centre press the joystick to

return to SETTINGS MENU.

Note: Showing inactive routes uses a lot of

operating memory on the unit, so it is important

to keep this selection to a minimum, as it will

slow down your unit. Showing too many

inactive routes could also 'freeze' your unit.

Only show a few short inactive routes, or to

reduce RAM consumption, choose the Show

Inactive Routes SP option.

Auto Clear Trail Data

• Use the joystick, moving left/right to toggle

between;

On: Trail data is cleared when a new route

is selected.

Off: Trail data is not cleared on new route

selection.

• Press Done or centre press the joystick to

return to SETTINGS MENU.

Auto Reset Log

• Use the joystick, moving left/right to toggle

between;

Keep Log on New Route: Log will not be

cleared when starting a new route.

Clear Log on New Route: Log will be

cleared on starting a new route.

• Press Done or centre press the joystick to

return to SETTINGS MENU

Pressing the Default button restores the

following settings:

Showing Inactive Routes

Show Inactive Routes SP

Auto Clear Trail Data

Off

Auto Reset Log

Keep Log on New Route

Control Data on

Map Screens

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 100 101

Comentarios a estos manuales

Sin comentarios